ASIC Hardware Diagnostics & Repair Masterclass
An intensive two-day practical workshop in our Seaton lab covering hashboard troubleshooting, domain voltage balancing, LDO testing, and micro-soldering.
Program Overview & Scope
Modern ASIC miners operate under harsh thermal and electrical stresses. This flagship masterclass equips technicians, farm operators, and independent miners with the exact diagnostic methodology required to isolate dead ASIC chips, trace signal clock degradation (CLK, RST, BO, RI), and perform precise micro-soldering repairs without destroying delicate copper traces.
Who This Course Is For
Mining farm operators, electrical technicians, electronics hobbyists, and commercial site managers looking to maintain hardware uptime in-house.
What Is Included (Deliverables)
- Individual workstation equipped with digital oscilloscope, thermal imaging camera, and hot-air rework station
- Comprehensive schematic walkthrough for Antminer S19/S21 and Whatsminer M30/M50 series hashboards
- Practical troubleshooting of domain voltages, Boost circuits, and low-dropout (LDO) regulators
- Hands-on chip replacement, ball-grid array (BGA) reballing, and solder paste reflow techniques
- Custom test fixture diagnostic interpretation and kernel log fault analysis
- Printed 140-page Lab Field Manual & Signal Tracing Workbook
- Certificate of Completion in ASIC Hardware Diagnostics
Prerequisites & Preparation
Basic understanding of electrical safety and multimeters. All safety gear, ESD protection, and tools are supplied in the workshop.
What Is Not Included
Personal travel, overnight accommodation in regional Victoria, and high-volume commercial warranty repairs for third-party hardware.
Detailed Schedule & Practical Sequence
Power Topologies & Signal Architecture
Deconstructing 3-phase power supplies, domain series architectures, step-down buck regulators, and serial signal chains (RX/TX, CLK, RST).
Diagnostic Jigs & Thermal Imaging
Connecting hashboards to test jigs, interpreting serial command outputs, identifying thermal bottlenecks, and isolating short circuits.
Micro-Soldering & BGA Chip Replacement
Hot air reflow profiles, flux selection, removing defective ASIC silicon, stencil reballing, and precise pad alignment.
Bench Validation, Flashing & Stress Testing
Verification on production test benches, control board kernel flashing, frequency scaling, and long-duration thermal validation.
Program Key Facts
Select your preferred weekend date or submit a workshop inquiry form to reserve an assigned lab station.
Other Practical Programs
Complementary engineering and operational workshops offered at Smart Work Point.
Mining Facility Electrical & Thermal Feasibility Audit
On-site engineering inspection of your transformer capacity, switchboard sub-distribution, cable ampacity, and positive-pressure ventilation.
Immersion Cooling & Dielectric Fluid Systems Course
Specialized training in dielectric fluid thermodynamics, pump head calculations, dry cooler heat rejection, and fan-spoof firmware.
Solar-Powered Mining & Grid Curtailment Strategy
Practical training for regional property owners on pairing rooftop solar PV and battery storage with automated dynamic mining load control.
Mining Farm Operations & Fleet Maintenance Bootcamp
Five-day immersive practical program training site technicians in preventative maintenance, power distribution, network topology, and batch servicing.
Private Technical Consultation & Hardware Inspection
Dedicated 3-hour private session with a senior hardware engineer for used hardware pre-purchase inspection or custom installation design.